催化剂薄层内甲烷水蒸气重整反应强化管内对流换热的数值模拟

本文以竖直圆管内壁催化剂薄层内发生甲烷水蒸气重整反应强化对流换热作为研究对象,对其进行了数值模拟．结果发现,催化剂薄层内的吸热化学反应可以有效地强化对流换热,降低流体和壁面温度,从而对壁面起到保护作用;极限热流密度的大小与流体的入口温度有关,存在最佳入口温度使极限热流密度最大．     

Ground-state properties of LiV2O4 and Li1-xZnx(V1-yTiy)2O4

We present susceptibility, microwave resistivity, NMR and heat-capacity results for Li_1-xZn_x(V_1-yTi_y)₂O₄ with 0 ? x ? 0.3 and 0 ? y ? 0.3. For all doping levels the susceptibility curves can be fitted with a Curie-Weiss law. The paramagnetic Curie-Weiss temperatures remain negative with an average value close to that of the pure compound Θ≈ - 36 K. Spin-glass anomalies are observed in the susceptibility, heat-capacity and NMR measurements for both type of dopants. From the temperature dependence of the spin-lattice relaxation rate we found critical-dynamic behavior in the Zn doped compounds at the freezing temperatures. For the Ti-doped samples two successive freezing transitions into disordered low-temperature states can be detected. The temperature dependence of the heat capacity for Zn-doped compounds does not resemble that of canonical spin glasses and only a small fraction of the total vanadium entropy is frozen at the spin-glass transitions. For pure LiV₂O₄ the spin-glass transition is completely suppressed. The temperature dependence of the heat capacity for LiV₂O₄ can be described using a nuclear Schottky contribution and the non-Fermi liquid model, appropriate for a system close to a spin-glass quantum critical point. Finally an ( x / y , T )-phase diagram for the low-doping regime is presented. Received 16 March 2001 and Received in final form 30 October 2001     

Active long pulse shaping technique of pulsed CO2 laser using multi-pulse discharge control

We describe the pulse forming of pulsed CO₂ laser using multi-pulse superposition technique. Various pulse shapes, high duty cycle pulse forming network (PFN) are constructed by time sequence. This study shows a technology that makes it possible to make various long pulse shapes by activating SCRs of three PFN modules consecutively at a desirable delay time with the aid of a PIC one-chip microprocessor. The power supply for this experiment consists of three PFN modules. Each PFN module uses a capacitor, a pulse forming inductor, a SCR, a high voltage pulse transformer, and a bridge rectifier on each transformer secondary. The PFN modules operate at low voltage by driving the primary of HV pulse transformer. The secondary of the transformer has a full-wave rectifier, which passes the pulse energy to the load in a continuous sequence.We investigated various long pulse shapes as different trigger time intervals of SCRs among three PFN modules. As a result, we could obtain laser beam with various pulse shapes and durations from about 250 to 1000 μs.     

一种高信噪比的双光束激光光声光谱仪原理及应用

作为一种新兴的检测手段 ,激光光声光谱技术与其他检测技术相比具有很多优点。本文设计的光声光谱仪用激光做光源 ,有两个光声池 ,分别用来放置参考样品和待测样品 ,输出结果为二者光声信号的比值。利用这一比值 ,可以由参考样品的性能参数方便地求出待测样品的相关性能参数。该光声光谱仪有效地减小了本底吸收噪声的影响 ,提高了信噪比 ,扩大了固体光声理论的应用范围。本文还阐述了该光声光谱仪在定性定量分析中的一些应用     

微光像增强器图像传递信噪比的测试研究

图像传递信噪比是微光像增强器的重要特性参数．能够全面定量地表征像增强器在探测弱辐射图像时的综合性能，对于确定像增强器的图像探测灵敏闽具有重要意义。针对其测试原理．采用高灵敏度低噪声CCD器件作为像管输出图像的探测接收器．并引入数字图像处理技术。利用设计的测试系统实现了典型目标图像传递信噪比的自动测试．多次实验结果表明．陔测试系统具有测试过程自动快速及测试数据准确稳定的优点．相同测试条件下的不确定度优于±3%。     

Co-P非晶态合金电子性质和局域结构的理论研究

根据Co P非晶态合金结构的短程有序和结构中可能存在P -P相互作用的实验事实 ,选择了单磷原子簇模型ConP(n =1～ 5 )和双磷原子簇模型ConP2 (n =1～ 4 ) ,用密度泛函理论方法对其进行计算 .结果表明 ,在单磷Co2 P( 2 ) 、Co3 P( 1) 及Co4P( 2 ) 模型体系中 ,Co原子供给P原子电子 ,与电负性规则一致 ,同时Co和P之间具较强化学作用 ,可以形成稳定的原子簇 ;而在双磷和单磷原子簇Co5P( 1) 模型体系中 ,形成的原子簇不稳定 ,采用单磷Co2 P( 2 ) 、Co3 P( 1) 及Co4P( 2 ) 模型能较好地反映Co P非晶态合金的结构特点 .     

Feedback controlled periodic states for different kinds of photorefractive nonlinear response

We investigate analytically and numerically the influence of the type of the photorefractive nonlinear response on the periodic states (attractors) which occur during feedback controlled 2W-coupling and correspond to almost 100% diffraction efficiency of the dynamic index grating. In addition to the case of the local response typical, for example, for LiNbO₃ crystals we consider the cases of nonlocal (diffusive) response (BaTiO₃, SBN) and resonant response (DC-biased BSO, BTO, and BGO crystals). It is shown that the conditions for the transition to the periodic states and their apparent characteristics are strongly different for the two limiting cases above. Received 16 July 2002 / Received in final form 29 October 2002 Published online 4 March 2003     

Ultraslow phonon-assisted collapse of tubular image states

We predict ultraslow collapse of “tubular image states” (TIS) on material surfaces. TIS are bound Rydberg-like electronic states formed at large distances (∼30 nm) from the surfaces of suspended circularly-symmetric nanowires, such as metallic C nanotubes. The states are formed in potential wells, resulting from a combination of the TIS-electron attraction to image charges in the nanotube and its centrifugal repulsion, caused by spinning around the tube. We demonstrate that TIS can collapse on the tube surface by passing their angular momentum l to circularly polarized flexural phonons excited in the tube. Our analysis shows that for highly detached TIS with l ? 6 the relaxation lifetimes are of the order of 10 ns-1 μs, while for l < 6 these lifetimes are reduced by several orders of magnitude.     

Reciprocating sliding wear behavior of laser-clad small amplitude Mo2Ni3Si/NiSi metal silicide composite coatings

Mo₂Ni₃Si/NiSi metal silicide composite coatings with a fine microstructure consisting of Mo₂Ni₃Si primary dendrites and the interdendritic Mo₂Ni₃Si/NiSi eutectics were fabricated on austenitic stainless steel AISI 321 by laser cladding process. Small amplitude reciprocating sliding wear resistance of the coatings is evaluated as functions of normal load and slip amplitude and the wear mechanisms were discussed based on worn surface morphology observations. Results showed that the Mo₂Ni₃Si/NiSi coatings have excellent small amplitude reciprocating sliding wear resistance.     

高频聚焦换能器声场的激光测量法

本文描述了一种使用激光测振技术测量高频聚焦换能器声场布的方法，并给出了使用该方法对一种高频聚换能器进行测量的结果，通过理论计算对结果的正确性进行了验证。